plate voltage

英 [pleɪt ˈvəʊltɪdʒ] 美 [pleɪt ˈvoʊltɪdʒ]

网络  阳极电压; 板极电压

电力



双语例句

  1. Check that the voltage plate on the motor is suitable for the supply voltage available.
    检查电动机上的电压板是否适合供电电压。
  2. Don't forget that the actual plate voltage swings both above and below the supply voltage, and the center of the swing is the actual plate supply voltage.
    不要忘记,实际板电压摆幅两个以上和以下的供电电压,和中心的摆动是实际板供电电压。
  3. If you lower the plate voltage by100V, you will find another "optimum" spot where these lines intersect.
    如果您降低板电压100V的,你会发现另一种“最佳”的地方这些线路相交。
  4. This is because the plate voltage is too high, and the max allowable current without exceeding dissipation limits is too low.
    这是因为板电压过高,最高不超过允许的电流损耗限制太低。
  5. The effect of circuit performance parameters on plate voltage stability, screen voltage stability and automatic brightness control are studied, and the developed circuit is compared with the external sample circuits in the main electric performances.
    研究电路性能参数对微光管电源的板压稳定性、屏压稳定性和ABC(自动亮度控制)性能的影响。比较研制电路与国外样品电路在主要电性能方面的差异及优劣。
  6. A high frequency VDMOS device with termination structure of a field plate, operating at high voltage, is designed by using a new method.
    作者采用一种新方法设计了可在高压下工作的高频VDMOS器件,该器件具有二级场板终端结构。
  7. Study on Formation of Surface Discharge on Dielectric Plate under Positive ns Impulse Voltage in Air The characterization of a ferroelectric liquid crystal light valve has been performed.
    空气中固体电介质上纳秒正脉冲表面放电过程具有点阵金属镜的FLC光阀特性的研究弭晓英,薛唯动波形的正脉冲使光阀处于关状态;
  8. Base on the technology of fast nickel brushing plating, the influence of plate liquid consistency, voltage, the pH value and plating speed on wear resistance were studied by adding Graphite particle into the fast nickel brushing plating liquid.
    在快速镍电刷镀技术的基础上,研究了在镀液中加入石墨微粒,通过改变镀液浓度、电压、pH值以及镀速等条件,达到改变镀层的耐磨性。
  9. Three different electrode geometries ( star shape wire-plate, needles-plate and plate-plate) and varied forms of voltage such as positive high voltage, negative high voltage, positive pulse voltage, negative pulse voltage and alternative voltage were tested.
    实验中我们使用了三种电极结构(星形线板,针板和板板)和不同波形的高压如正高压、负高压、正脉冲、负脉冲和交流高压等。
  10. In this paper the moving process of electrons injected into anode is simulated by Monte Carlo method, and the radiation energy spectrum, angle distribution in positive rod plate gap with different voltage and different electrod materials are calculated.
    本文利用电子光子MonteCarlo方法模拟单个电子入射阳极后的游动厉史,运用不同的电极材料,计算了正针负板电极在不同的冲击电压作用下所产生的X射线的能量分布及角度分布。
  11. The influence of plate voltage of the oscillator, gas pressure and extraction voltage on the quality of ion beam is determined and analysed.
    测试并分析了振荡器板压、离子源气压和引出电压对离子束品质的影响;
  12. The influences of the geometrical size of plate, functionally gradient index and displacement at mid-plane of plate on the critical voltage are discussed.
    在此基础上,讨论了板的几何尺寸、材料梯度指数的变化和中面变形等因素对临界电压(电载荷)的影响。
  13. Electron launching resulted in positive voltage signal of collector plate, and ion launching resulted in negative voltage signal of collector plate.
    收集板上的正、负电压信号分别由激光烧蚀金属Cu产生离子和电子发射而引起,高能电子对环境气体具有碰撞电离的作用。
  14. This paper reports the exact solution and the approximate solution of forced vibration of general metal-piezoceramic thin composite circular plate excited with voltage.
    本文报告了电压策动下的复合薄圆板的强迫弯曲振动的严格解和近似解。
  15. The effect of residual charges on an insulating plate upon the surface discharge voltage
    绝缘板表面残余电荷对沿面放电的影响
  16. Piezoelectric elements were bonded on the plate as actuators and the input voltage of each actuator was determined by the velocity of its position and volume velocity of the plate was made zero, through which the sound radiation from the plate could be controlled.
    在简支薄板表面粘贴压电片作为致动器,根据所处位置的速度确定输入控制电压,并使平板的体积速度为零,从而达到控制声辐射的目的。
  17. Design and Application of the Quarter Wave Plate in Optical Voltage Transformer
    光学电压传感器中λ/4器件的设计与应用
  18. The composition of the cations from the near cathode region was characterized with molecular beam mass spectroscopy ( MBMS) in the wire plate, high voltage pulse corona discharge induced N 2+ O 2 plasma.
    利用具有三级差分抽气系统的分子束质谱仪为检测手段,对N2,O2混合气体的线板式高压脉冲电晕放电等离子体阴极板区的正离子成分进行了诊断研究。
  19. Gel batteries can decrease plate sulfation, increase discharge voltage, it recovers quickly after discharging. Their cumulative capacity and power increase with intermittent discharging.
    Gel电池能减缓极板硫酸盐化,放电电压高、电压恢复快、电池功率大、间断放电累计容量增大、续驶里程远。
  20. To analyze the formation of surface discharge on a dielectric plate under positive nanosecond impulse voltage in air, a wire to plane electrode system with a barrier of negative film was used.
    采用感光胶片作为阻挡介质的针-板放电系统,解析空气中固体电介质上纳秒正脉冲表面放电的形成过程。
  21. Study on the Field Plate Termination Technology of High Voltage VDMOS
    高压VDMOS场板终端技术的研究
  22. Prediction of Performances for Silicone Plate under Non-Sinusoidal Voltage Waveform
    非正弦电压下硅钢片材料特性的预测
  23. The authors will discuss the melting and casting technology to produce Cu Cr alloy casting, employing usual melting equipment and molding materials. The electric contact plate withstanding high voltage and current will serve as an example.
    以采用常规的熔炼设备和造型材料熔铸出Cu-Cr合金铸件&高压大电流电极触头板为例讨论这一熔铸的工艺方法。
  24. The results of research show that the amounts of residual charges on a dielectric plate vary with the values of voltage upon it.
    研究结果表明:在绝缘板上施加不同的电压,板面上将残余不同的电荷;
  25. The experiments were carried out to investigate the effects of plate distance, electrolytic voltage, current density, ionic strength, pH, initial concentration, and electrolysis time on removal efficiency and reaction kinetics.
    考察了极板间距、电解电压、电流密度、离子强度、pH值、初始浓度和电解时间对去除效率的影响,并对反应动力学进行了探讨。
  26. Pockels cell is a variable wave plate controlled by voltage, the control voltage is about 800V. To drive pockels cell needs to design a specialized high-voltage driver module.
    克尔盒是利用克尔效应,由电压控制的可变波片,其控制电压约800V,驱动克尔盒需要设计专门的高压驱动模块。